If you’ve ever unplugged your garage door opener by accident or had a power outage and the opener reset, you may have wondered if there was a way to quickly reprogram the remote. Well, wonder no more!
In this article, we’ll show you how to reset your electric garage door opener the right way- and how to quickly reprogram the remote if a power outage or accidental unplugging reset the opener.
Does Unplugging a Garage Door Opener Reset It?
Yes, unplugging a garage door opener will reset it. When you unplug the opener, all of its programmed settings are erased. The next time you plug it in, you’ll need to reprogram it to your specific needs. Be sure to read the manufacturer’s instructions carefully so that you do it correctly.
Some openers come with a backup battery, which will keep the unit running even if the mains goes out. If your garage door opener has this feature, it’s likely that a brief power outage or unplugging it will not reset the appliance and erase all settings.
What Happens When You Unplug Your Garage Door Opener?
First, let’s talk about what happens when you unplug your garage door opener.
When you do this on an older model without a battery backup it resets the opener’s memory. This means that any programmed settings – such as the code for your remote – are erased.
Most newer models come with or are required to have a battery backup. This is a feature that helps keep the opener running in the event of a power outage. If your opener has this feature, then a power outage or unplugging it should not reset it.
However, if the battery is dead, then the unit will reset and you’ll need to reprogram it.
How to Quickly Reprogram Your Garage Door Opener Remotes and Keypads
If your garage door opener has been reset, or you’ve just purchased a new one and need to program the remote, follow these steps:
1. Locate the “Learn” button on your garage door opener unit. It is usually located near the hanging antenna on the back or side of the motor unit.
2. Press and release the “Learn” button. The indicator light will flash once to signal that it is in program mode.
3. Within 30 seconds, press and hold the button on your remote control transmitter until the garage door opener motor unit’s lights blink. Release the button on the remote control transmitter. The garage door opener has now learned the code for your remote control transmitter. Repeat this step to program additional remote control transmitters.
4. To program a wireless keyless entry pad, press the “Learn” button on the garage door opener motor unit and then enter your 4-digit PIN code followed by the “Enter” button on the wireless keyless entry. The garage door opener will flash to indicate that it has learned the code.
If you have any questions about resetting or programming your garage door opener, be sure to consult your owner’s manual or contact the manufacturer directly.
Conclusion
We hope this article has helped clear up any confusion about resetting your garage door opener. Remember, unplugging the unit will erase all programmed settings, so be sure to have your manual handy so that you can quickly reprogram the device. And if you have a newer model with a battery backup, a power outage or accidental unplugging shouldn’t erase your programmed settings.